You need to know what finish you are using prior to using any stain because some finishes add a bit of color. What are you finishing your project with? Is it oil-based poly, water based polycrylic, wax, oil, etc. Once you’re finished with your sanding use a tack cloth to remove every bit of dust in preparation for staining. Start with a 40 to 60-grit for removal of the old finish and then move to 80-grit followed by 120-grit. Make sure that you work up methodically through each grit along the way to avoid swirl marks or sanding flaws. Keeping your final grit in this range allows for even distribution of the wood stain pigments. I have found that the sweet spot for wood stain is between 120-150 grit depending on the wood. Sanding to too fine a grit will result in wood that may not even be able to take in the pigments efficiently since the openings are too small. Sanding wood too coarsely will create a darker appearance since there are larger pores and a rougher surface in the wood. When using wood stain it’s imperative to sand to the right grit. The opinions are completely my own and I have been using these products and techniques long before partnering with Minwax for this post. This post was sponsored by Minwax who makes, in my opinion, the best wood stains for historic restoration. In this post, I’ll walk you through five of my best tips and techniques to achieve that perfect color match you are looking for. I’ve worked in historic restoration restoring wood doors and windows for years and if there is one thing I’ve learned it’s how to creatively use wood stains and finishes to get a perfect looking match. Matching an existing wood stain to make sure your work doesn’t stick out like a sore thumb requires a good eye and some careful work. Always test stain on a hidden area of the wood to verify desired color.If you’ve got a stained wood project that you need to perhaps repair or refinish and you need to match the stain colors it can be challenging to say the least. The colors shown are for reference purposes only. Recommended Uses: unfinished wood furniture, woodwork, doors, hardwood floors, cabinets, accessories and trim ![]() To darken the color, apply a second coat after 2-4 hours (time dependent on color). Perfect for interior staining unfinished wood furniture, cabinets, doors, trim, molding and floors.Īpplication Tool: natural bristle brush, or clean clothĬleanup: mineral spirits or paint thinnerĬoats: 1 coat. ![]() Can be used to add beauty to any bare or stripped wood surface.Dries in 2 hours makes it possible to stain in a day.Deeply penetrating color enhances wood’s beauty in one coat.Slight ambering may occur when these finishes are applied over light or really dark colored stains. Be sure to protect your project by applying a clear protective finish, following label directions. Recommended finishes include Minwax® Fast Drying Polyurethane or Helmsman® Spar Urethane. Stain adds beauty and color to the wood surface. Minwax's innovative formula delivers the same premium oil-rich color as before, but in a single coat that dries in just two hours. ![]() Minwax® Wood Finish™ is a penetrating oil-based wood stain, which provides beautiful rich color that enhances the natural wood grain.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |